Exclusive-distributor for USA & Canada:
ERC-Mini SDX was designed especially for the SDX-series rotators of Yaesu/Kenpro. It comes ready assembled and tested and will be mounted directly inside the Yaesu/Kenpro control-box.
Included with the ERC-Mini SDX:
- Ready assembled and tested ERC-Mini SDX with USB-interface
- Mounting material (bolts, screws, etc) for direct-mount inside the SDX-control-box
- Service-Tool (Windows XP/Vista/7/8/10 32 and 64bit) for configuration and calibration.
- Rotor-Control Software (Windows XP/Vista/7/8/10 32 and 64bit)
SPECIFICATION ERC-Mini SDX
- Size of printed board : 67mm x 37.5mm
- Supply-voltage : 5 VDC through USB, max 10mA
- Operating-temperature : 0 to 70°
- Measuring-circuit for the rotator-feedback-voltage : 0 to +6V, Input-Impedance > 25 KOhm.
- Resolution : 10bit.
- Software-driven calibration with calibration-assistant.
- Full support for rotators with overlap up 180°
- Security-stop, if the rotators doesn´t move
- Outputs-circuits :
- open-collector-outputs for CW, CCW
- 4-stage speed-control with DAC
- Communication-port: USB with FTDI-chipset. Baudrate configurable 4800-9600 Baud
- Controller with bootloader.
- ERC-Mini SDX is compatible to a subset of the following protocols :
- Hygain DCU-1 with extension for position-feedback
- Yaesu GS232A
- Yaesu GS232B
- Programs with which ERC-Mini SDX has been checked successfully : see Software-guide
- Compatible rotators: Yaesu/Kenpro SDX-series G/KR-800/1000/2700/2800 SDX
- Firmware supported features:
- delay before rotator starts moving
- programmable end-stops
- antenna offset
- support of overlap up to 180°
- tolerance of position
- save and load of all calibration- and configuration-data
- More details are available in the instructions in the File-section below.
RoHS : ERC-Mini and the components used are according to the EG-directive 2002/95/EG to avoid usage of hazardous substances in electronic equipment.
This Product was added to our catalogue on 07/06/2015.
modified eCommerce Shopsoftware © 2009-2021